Skip to contentBuilt for the next shift.Explore OpenHandover’s early access

Food safety · Free template

Fridge temperature log

A fridge and freezer temperature log for kitchens and cafés: twice-daily readings, the target for each unit, and what was done when a reading was out of range.

When
At least twice a day, for example at opening and mid-afternoon. Plan about 10 minutes.
Who
Whoever is responsible for the kitchen at the time, usually the opening chef.
Repeats
Every day · about 10 minutes
Use it in OpenHandover

A fridge temperature log is only as useful as what happens when a reading is wrong. A sheet full of ticks proves little; a sheet that shows a fridge at 9°C, what was moved and when the engineer came shows a kitchen in control.

This template records a real reading for each fridge and freezer, compares it with the target, and asks what was done whenever a reading is out of range. Add a row for every unit you have, and take readings at the same times each day.

The checklist

  1. Fridge 1Target: 5°C or below
  2. If “Fridge 1” is out of range:What did you do about it?
  3. Fridge 2Target: 5°C or below
  4. If “Fridge 2” is out of range:What did you do about it?
  5. Freezer 1Target: −18°C or below
  6. If “Freezer 1” is out of range:What did you do about it?

This is the same template OpenHandover teams start from. Edit it to match your own procedures.

Getting it right

  • Do not take a reading straight after a delivery or a busy spell with the door open; it will read high. Wait and read again.
  • Use a clean probe or a thermometer you have checked, and say which you used if it matters to your plan.
  • This template flags fridges above 5°C and freezers above −18°C. Set the targets to the ones in your own food safety plan. The Food Standards Agency’s Safer Food, Better Business pack is a good place to start if you do not have one.

Using it in OpenHandover

In OpenHandover each reading is checked against its target as it is entered, an out-of-range reading asks what was done, and a missed check alerts the department’s leads. Sites with temperature sensors can see readings come in alongside the checks.

Run it every day, not just print it.

OpenHandover puts this check on your team’s Today screen at the right time, records who did it, and turns a problem into an issue with an owner.

Get started with OpenHandover