Skip to contentBuilt for the next shift.Explore OpenHandover’s early access

Food safety · Free template

Probe thermometer check

A monthly probe thermometer check: read each probe in iced water and in boiling water, record the results, and note what was done if a probe reads wrong.

When
Once a month, and whenever a probe has been dropped or gives a reading that looks wrong. Plan about 10 minutes.
Who
The head chef or kitchen lead.
Repeats
Every month · about 10 minutes
Use it in OpenHandover

Every temperature record in a kitchen depends on the probe being right. A probe that reads two degrees low makes a fridge at 7°C look fine. A quick monthly check in iced water and boiling water shows whether each probe can be trusted.

This template records which probe was checked, its reading in iced water and its reading in boiling water, and asks what was done if either is outside the range. Usually that means a new battery, recalibrating it as the maker describes, or replacing the probe.

The checklist

  1. Which probe
  2. Iced waterFill a jug with ice and a little water, stir, and wait a minute before probing.
  3. Reading in iced waterTarget: −1 to 1°C
  4. If “Reading in iced water” is out of range:What did you do about it?
  5. Boiling waterTake care with boiling water. Probe the water, not the kettle.
  6. Reading in boiling waterTarget: 99 to 101°C
  7. If “Reading in boiling water” is out of range:What did you do about it?

This is the same template OpenHandover teams start from. Edit it to match your own procedures.

Getting it right

  • Give each probe a name or number so the record shows which one was checked.
  • Stir the iced water and wait a minute before reading; the water needs to settle.
  • This template treats −1 to 1°C in iced water and 99 to 101°C in boiling water as accurate, the ranges commonly used in UK kitchens. Use the ones in your own food safety plan.

Using it in OpenHandover

In OpenHandover each reading is checked against its range as it is entered, and a probe outside the range asks what was done before the check can be finished.

Run it every day, not just print it.

OpenHandover puts this check on your team’s Today screen at the right time, records who did it, and turns a problem into an issue with an owner.

Get started with OpenHandover